Waste Appliance Crushing & Recycling
Dismantle and crush end-of-life appliances, then split out ferrous, non-ferrous and plastic fractions for separate sale.
Refrigerators, washing machines and air conditioners are composite products. Landfilling or shredding them as mixed waste loses recoverable metal and creates disposal cost.
Separated ferrous, non-ferrous and plastic streams, with refrigerant and compressor handling addressed before crushing.
How the line runs
- 01
Manual dismantling
Compressors, motors and refrigerant circuits are removed first — these need separate handling and should not enter the crusher.
- 02
Crushing
Vertical or horizontal crushing reduces the appliance body and remaining assemblies to a uniform size.
- 03
Magnetic separation
Ferrous shells, shafts and frames are lifted out of the stream magnetically.
- 04
Non-ferrous recovery
Eddy current separation recovers copper windings, aluminium and brass from the non-magnetic fraction.
- 05
Plastic and foam
The remaining plastic and insulation fraction is separated for recycling or controlled disposal.
Machines specified for this process
Vertical Crusher
Vertical shaft crusher for reducing crushed scrap and motor housings to a uniform, denser output before separation or baling.
Industrial Metal Shredder
Single-, dual- and four-shaft shredders that reduce bulky metal scrap to a consistent 50–300 mm output, with anti-jam reversal and hardened blade sets.
Eddy Current Separator
High-frequency rotor that ejects aluminium, copper and zinc from mixed streams, separating particles down to 3 mm at >99% aluminium recovery.
Send the material mix, get a stage sequence
We do not quote a line from a description alone. Send the composition, throughput and site constraints, and the reply will be a proposed flow with the equipment that fills each stage — and an honest note on what you can skip.
- Material test available
- Layout drawings
- On-site commissioning